• Close three-quarter view of the brass gooseneck arm, round backplate and white cone shade of this Clérachic wall light against a sheer curtain.
  • A brass gooseneck arm and round backplate carry a white cone shade, this Clérachic wall light shown on a plain pale backdrop.
  • Two lit white cone shades on slim arms flank a window above a farmhouse sink, a pair of Clérachic wall lights over white tile and a butcher-block counter.
  • On cream shiplap above a rustic console with books and a fern, this Clérachic wall light hangs its white cone shade from a brass arm.
  • Beside a mudroom bench with plaid cushion and woven baskets, a Clérachic wall light glows softly on a white shiplap wall.
  • A Clérachic wall light in a nickel-toned finish glows above a pedestal sink, beside a wood-framed mirror and white tile.
  • Two Clérachic wall lights with white cone shades frame a sash window over a deep sink, with brass taps and a plaid blind.
  • Lit white cone shade on a brass arm, this Clérachic wall light hangs above a small wooden side table and a navy armchair on a cream wall.
  • Above a bedside table with a clock and mug, a Clérachic wall light in a nickel-toned finish lights a bed dressed in linen and plaid.
  • Seen from slightly below, the white cone shade and curved brass arm of this Clérachic wall light stand out against a soft white curtain.
  • A small view of this Clérachic wall light on a pale wall, its white cone shade lit, with a leafy fern in the lower corner.
  • This Clérachic wall light is seen from a distance on a pale wall, with the white cone shade lit and a fern at the right.
  • A white cone shade on a brass arm, this Clérachic wall light lit on a light wall beside a draped lace curtain.
  • The lit white shade of this Clérachic wall light hangs low on its brass arm, with a green fern and a curtain beside it.
  • Side view of the brass gooseneck arm, with its turned collar and wide white cone shade, on this Clérachic wall light.
  • Brass backplate, curved arm and white cone shade of this Clérachic wall light, seen from the side against a pale wall.
  • Viewed from below, the open underside of the white cone shade and the brass lamp holder of this Clérachic wall light.
  • Front view of this Clérachic wall light, with the curved brass arm rising behind the white cone shade.
  • Close view of the round brass backplate and the arm leaving it on this Clérachic wall light.
  • Close view of the brass lamp holder with its knurled ring and the top of the white cone shade on this Clérachic wall light.
  • Looking up into the white cone shade of this Clérachic wall light, with the bulb visible inside and the brass backplate in the corner.
  • The lit bulb glows inside the white cone shade, warm light filling its interior on this Clérachic wall light.
  • Close view of the rim of the white cone shade, with the warm glow of the bulb inside, on this Clérachic wall light.
  • Close view of the outside of the white cone shade, with the brass lamp holder above it, on this Clérachic wall light.
  • This Clérachic wall light hangs on a white backdrop, its brass arm bending down to a white cone shade.
  • Seen slightly from below on a pale wall, this Clérachic wall light shows the inside rim of its white cone shade and the brass arm above.
  • Mirror-image side view of this Clérachic wall light on white, with the brass arm bending to the right above the white cone shade.
  • This Clérachic wall light in a nickel-toned finish has a brushed metal arm and backplate with a white cone shade, on a white backdrop.
  • This Clérachic wall light in a brass finish has a warm metal arm and backplate with a white cone shade, on a white backdrop.
  • Two white cone shades without arms stand on a wooden sideboard, each with a round hole at the top for the lamp holder, for this Clérachic wall light.
  • Close view of two white cone shades on a wooden surface, showing the round opening at the top of each, for this Clérachic wall light.
  • Two white cone shades sit side by side on a wooden sideboard, shown from the side, for this Clérachic wall light.
  • Nickel-toned arm and backplate with a white cone shade, this Clérachic wall light on a pale wall beside a sheer curtain.
  • This Clérachic wall light in a black finish has a black arm and backplate with a white cone shade, on a white backdrop.
  • Black arm, round backplate and white cone shade, this Clérachic wall light seen from the side on a white backdrop.

Gooseneck Wall Light, White Cone Shade, Brass Arm, Wall Sconce

€159Incl. VAT & Free Shipping

Size24 × 32 × 35 cm

Colour Brass & White
1

Arrives in France within Dec 2–9

Description

A curved metal gooseneck arm carries a flared cone shade and aims the light downward. The materials are metal, brass, aluminium and ceramic, and the fitting takes an E26 or E27 bulb, LED or Edison.

Choose Brass & White, Nickel & White or Black & White, and an aluminium or a ceramic shade. The light is hardwired and wall mounted, and its compact size suits a bedroom mirror or a kitchen sink.

Shipping & delivery

Free shipping to France on every order, with no minimum.

Each piece is made to order, so allow 7 to 12 business days in total. Order today and you can expect it between 1 December and 8 December.

Returns & exchanges

Return or exchange it within 30 days of delivery, unused and in its original packaging. No restocking fee. Return shipping is paid by you unless the item is defective, damaged or incorrect.

Payment options
  • AliPay
  • American Express
  • Apple Pay
  • Bancontact
  • Bizum
  • BLIK
  • Google Pay
  • Maestro
  • Mastercard
  • MB WAY
  • Satispay
  • Shop Pay
  • Union Pay
  • Visa

Questions about sizes or finishes? Email info@clerachic.com and we will reply within 24 hours on business days.

The details

Everything you need to know before it arrives

A curved metal gooseneck arm carries a flared white cone shade, aiming the light downward. The body comes in brass, nickel, black or white.

Installation guide

Every wall light in this collection mounts to the wall with the hardware included in the box. The steps below cover all three power types we supply - hardwired, plug-in and rechargeable - so read the first section, work out which one you have, then follow the matching path.

Before you start

  • Power type: your light is hardwired, plug-in or rechargeable. The Product Specifications above say which. It changes the whole installation, so check before you open anything.
  • Mounting: all wall lights fix to a flat wall surface. Screws, anchors and the mounting bracket are supplied.
  • Dimming: lights with a standard replaceable bulb can usually be dimmed. Integrated LED models generally cannot. The specification above states which your model is.
  • Indoors or out: only fit a light outside if its IP rating says it is suitable. An indoor-rated fitting will fail quickly in the weather and is unsafe in the wet.
  • Wall type: plasterboard, brick and tile each need their own anchor. The supplied screws suit standard plasterboard; buy the right fixing for anything else.

Tools you may need

  • Screwdriver
  • Voltage tester
  • Wire nuts or terminal connectors (supplied with hardwired models)
  • Drill and a bit suited to your wall, if you are making a new fixing point
  • Spirit level and pencil

If your light is hardwired

1. Switch off the power

Turn the lighting circuit off at your consumer unit or breaker panel. Do not rely on the wall switch. Test the wires at the outlet box with a voltage tester and confirm they are dead before you touch them.

2. Remove the old fitting

If you are replacing an existing light, unscrew it and disconnect the wires by undoing the connectors. Support the fitting as you free it so it does not hang on its wiring.

3. Fit the mounting bracket

Hold the new bracket against the outlet box or your marked position and check it with a level. Fix it with the supplied screws, tightening evenly so the bracket sits flat against the wall.

4. Connect the wiring

  • Live to live: black, brown, or the terminal marked L
  • Neutral to neutral: white, blue, or the terminal marked N
  • Earth to earth: green, green-and-yellow, or bare, to the earth terminal or screw

Twist each pair together and secure it with a connector. Tuck the wiring back into the box so nothing is pinched when the fitting closes onto the bracket.

5. Mount the fitting

Line the body up with the bracket and secure it with the screws provided. It should sit flush to the wall with no gap and no movement.

6. Fit the bulb

If your light takes a replaceable bulb, fit the type and wattage given in the Product Specifications above. Do not exceed the wattage printed on the socket.

7. Restore power and test

Switch the circuit back on and test the light. If it does not come on, isolate the power again before you re-open anything.

If your light is plug-in

Fix the bracket to the wall with the screws and anchors supplied, checking it with a level. Attach the body to the bracket, then run the cable to the nearest socket. Clip or tuck the cable so it is not a trip hazard and is not pulled taut where it leaves the fitting.

If your light is rechargeable

Fix the bracket to the wall, then charge the light fully with the supplied cable before its first use - a first charge from flat takes longer than later ones. Seat the light on its bracket and switch it on. Most models lift off the bracket for recharging without tools.

Important tips

  • Follow the wiring rules that apply where you live. If any part of this is unfamiliar, have a qualified electrician do it - it is a short job for them.
  • Check the outlet box is sound and can carry the weight of the fitting before you mount it.
  • Dust the fitting occasionally with a dry, soft cloth. Do not use solvents or abrasive cleaners on a painted or plated finish.
  • Let a bulb cool before you handle it, and never fit a bulb above the rated wattage.

If anything about the fitting or the wiring is unclear, email info@clerachic.com and a person will answer you.

Specifications
Dimensions
24 cm × 32 cm × 35 cm (9.4″ × 12.6″ × 13.8″)
Material
Metal, brass, aluminium, ceramic
Bulb
E26 or E27 socket, LED or Edison bulb
Voltage
AC 110–240 V
Control
Works with a standard wall switch (not included), which controls the electricity supply
Wiring
Hardwired
Mounting
Wall mount
Finish
Brass & White, Nickel & White, Black & White
In the room

See it in the room

On cream shiplap above a rustic console with books and a fern, this Clérachic wall light hangs its white cone shade from a brass arm.
Two Clérachic wall lights with white cone shades frame a sash window over a deep sink, with brass taps and a plaid blind.
Lit white cone shade on a brass arm, this Clérachic wall light hangs above a small wooden side table and a navy armchair on a cream wall.
Close view of two white cone shades on a wooden surface, showing the round opening at the top of each, for this Clérachic wall light.
Designed in Oslo The Clérachic edit Designed in Oslo
The object

Why you'll love it

  • Curved gooseneck arm directs light downward
  • Flared cone shade in white
  • Body finish in brass, nickel, black or white
  • Compact: 24 cm across, 32 cm wide and 35 cm tall
Complete the room

You might also like...

FAQ

Questions, answered

Should I choose aluminium or ceramic for the lampshade?

Aluminium shades are metal and safer during transport. Ceramic shades are light-transmissive, allowing more diffused glow. Both mount identically; choose based on aesthetic preference and light diffusion desired.

Which metal finish works best with my décor?

Brass & White suits warm, traditional spaces. Nickel & White complements modern or industrial settings. Black & White works with both. All three are offered; select based on your existing hardware and finishes.

What type of bulb does this sconce use?

This light accepts E26 or E27 base LED or Edison bulbs. It runs on AC 110–240 V and wires hardwired to an external wall switch for control.

What are the exact dimensions of this wall light?

The sconce measures ∅ 24 cm × W 32 cm × H 35 cm.

What if it isn't right for my room?

Return or exchange it within 30 days of delivery, unused and in its original packaging. No restocking fee. Return shipping is paid by you unless the item is defective, damaged or incorrect. Refunds are issued within 7 business days.

How long does delivery take?

Orders placed before 17:00 (GMT+1) are processed in 1–2 business days, then 6–10 in transit: 7–12 business days in total. Shipping is free on every order, and you get a tracking link by email.

What if it arrives damaged?

Email photos of the item and packaging to info@clerachic.com within 48 hours of delivery and we will send a replacement or refund.

Seen from slightly below, the white cone shade and curved brass arm of this Clérachic wall light stand out against a soft white curtain.
Free advice before you buy

Not sure it suits your room?

Tell us about the space and the ceiling height, and a person on the team will tell you how it will look and fit.

  • info@clerachic.com · we reply within 24 hours on business days
  • Monday to Friday, 09:00–17:00 (GMT+1)
  • Still unsure? Return or exchange within 30 days of delivery.