• Bedroom with a linen headboard and white pillows, a two-head Clérachic wall light in brass hanging above a bedside table.
  • Plain backdrop studio shot of this Clérachic wall light, two veined alabaster cylinder shades hanging at different heights from a brass wall plate.
  • Entryway scene with a ceramic vase of dried stems on a walnut console, a two-head Clérachic wall light glowing warm on a limewashed wall.
  • Bathroom with an arched brass mirror and marble vanity, a Clérachic alabaster wall light lit warm on each side of the mirror.
  • Living room corner with a walnut sideboard and an armchair, a two-head Clérachic wall light glowing amber beside a large abstract painting.
  • Sunlit living room with an armchair and a live-edge console table, a two-head Clérachic wall light lit warm beside a framed abstract print.
  • Reading corner with a leafy plant, an armchair and a marble side table, a Clérachic wall light with two alabaster shades glowing softly.
  • Close view of a single lit alabaster cylinder on this Clérachic wall light, glowing amber against a dark wall beside an arched doorway.
  • This Clérachic wall light on a grey plaster wall, two unlit alabaster cylinders with brown veining hanging from brass spheres and a round plate.
  • Close-up of the round brass wall plate and arm of this Clérachic wall light, with the top of a brass sphere below.
  • Detail of an alabaster cylinder shade on this Clérachic wall light, its pale, softly veined stone beneath a brass sphere and a slim arm.
  • Single-head Clérachic wall light on a pale wall, a brass plate, arm and sphere above a white alabaster cylinder.
  • Two-head Clérachic wall light in brass on a dark charcoal wall, its alabaster cylinders showing cream and tan veining.
  • Nickel-finish Clérachic wall light on a pale wall, two alabaster cylinders glowing softly beneath brushed silver spheres and a round plate.
  • Black-finish Clérachic wall light on a pale wall, two lit alabaster cylinders with grey veining hanging from black spheres.
  • Single-head Clérachic wall light in brass on a marble wall with slim vertical mouldings, its alabaster cylinder lit warm and seen at an angle.
  • Single-head Clérachic wall light in brass on a white wall, the alabaster cylinder glowing amber with strong veining.
  • Two-head brass Clérachic wall light on a pale wall, one alabaster cylinder lit warm white while the other hangs higher and unlit.
  • Single-head Clérachic wall light in black on a white wall, with a veined alabaster cylinder hanging from a black sphere.
  • Single-head brass Clérachic wall light on a white wall, its alabaster cylinder glowing orange-amber, veining clearly visible.
  • Single-head Clérachic wall light in nickel on a white wall, a veined alabaster cylinder below a brushed silver sphere and round plate.
  • Two-head Clérachic wall light in brass on a white wall, unlit alabaster cylinders with grey and gold veining beneath brass spheres.
  • Two-head brass Clérachic wall light on a pale wall, the lower alabaster cylinder lit warm white and the upper one unlit.
  • Single-head brass Clérachic wall light on a white wall, an unlit marble-white alabaster cylinder below a brass sphere and plate.
  • Two-head Clérachic wall light in black on a grey wall, two alabaster cylinders lit to a soft white glow.
  • Two-head Clérachic wall light in nickel on a grey wall, two alabaster cylinders lit white below brushed silver spheres.
  • Single-head Clérachic wall light in brass on a pale stone wall with slim mouldings, its alabaster cylinder glowing warm amber.
  • Studio view on a white backdrop of a two-head Clérachic wall light in brass, two unlit alabaster cylinders with brown veining.
  • Smaller studio view on white of this two-head Clérachic wall light in brass, with brown-veined alabaster cylinders hanging from brass spheres.
  • Studio shot on a pale grey backdrop of a two-head Clérachic wall light, brass arms and spheres above two veined alabaster cylinders.
2 sizes

Alabaster Shade Wall Light, Wall Sconce, 36 to 45 cm Tall

$265Incl. VAT & Free Shipping
Colour Lacquered Burnished Brass & White
1

Arrives in United States within Nov 30–Dec 7

Description

A wall lamp with a white alabaster shade on a brass, black or nickel metal body. It takes a G9 LED bulb and gives a warm, ambient light that suits bedrooms, hallways and living rooms.

Choose one head at 36 cm (14.2″) tall, or two heads at 45 cm (17.7″) in a left or right orientation. It is hardwired to the wall.

Shipping & delivery

Free shipping to United States on every order, with no minimum.

Each piece is made to order, so allow 7 to 12 business days in total. Order today and you can expect it between 30 November and 7 December.

Returns & exchanges

Return or exchange it within 30 days of delivery, unused and in its original packaging. No restocking fee. Return shipping is paid by you unless the item is defective, damaged or incorrect.

Payment options
  • AliPay
  • American Express
  • Apple Pay
  • Bancontact
  • Bizum
  • BLIK
  • Google Pay
  • Maestro
  • Mastercard
  • MB WAY
  • Satispay
  • Shop Pay
  • Union Pay
  • Visa

Questions about sizes or finishes? Email info@clerachic.com and we will reply within 24 hours on business days.

Size guide

Find the right size

Size
Dimension drawing: W7 x L15 x H45 cm
The details

Everything you need to know before it arrives

A wall lamp with a white alabaster shade on a brass, black or nickel body, in one-head or two-head form, 36 to 45 cm tall.

Installation guide

Every wall light in this collection mounts to the wall with the hardware included in the box. The steps below cover all three power types we supply - hardwired, plug-in and rechargeable - so read the first section, work out which one you have, then follow the matching path.

Before you start

  • Power type: your light is hardwired, plug-in or rechargeable. The Product Specifications above say which. It changes the whole installation, so check before you open anything.
  • Mounting: all wall lights fix to a flat wall surface. Screws, anchors and the mounting bracket are supplied.
  • Dimming: lights with a standard replaceable bulb can usually be dimmed. Integrated LED models generally cannot. The specification above states which your model is.
  • Indoors or out: only fit a light outside if its IP rating says it is suitable. An indoor-rated fitting will fail quickly in the weather and is unsafe in the wet.
  • Wall type: plasterboard, brick and tile each need their own anchor. The supplied screws suit standard plasterboard; buy the right fixing for anything else.

Tools you may need

  • Screwdriver
  • Voltage tester
  • Wire nuts or terminal connectors (supplied with hardwired models)
  • Drill and a bit suited to your wall, if you are making a new fixing point
  • Spirit level and pencil

If your light is hardwired

1. Switch off the power

Turn the lighting circuit off at your consumer unit or breaker panel. Do not rely on the wall switch. Test the wires at the outlet box with a voltage tester and confirm they are dead before you touch them.

2. Remove the old fitting

If you are replacing an existing light, unscrew it and disconnect the wires by undoing the connectors. Support the fitting as you free it so it does not hang on its wiring.

3. Fit the mounting bracket

Hold the new bracket against the outlet box or your marked position and check it with a level. Fix it with the supplied screws, tightening evenly so the bracket sits flat against the wall.

4. Connect the wiring

  • Live to live: black, brown, or the terminal marked L
  • Neutral to neutral: white, blue, or the terminal marked N
  • Earth to earth: green, green-and-yellow, or bare, to the earth terminal or screw

Twist each pair together and secure it with a connector. Tuck the wiring back into the box so nothing is pinched when the fitting closes onto the bracket.

5. Mount the fitting

Line the body up with the bracket and secure it with the screws provided. It should sit flush to the wall with no gap and no movement.

6. Fit the bulb

If your light takes a replaceable bulb, fit the type and wattage given in the Product Specifications above. Do not exceed the wattage printed on the socket.

7. Restore power and test

Switch the circuit back on and test the light. If it does not come on, isolate the power again before you re-open anything.

If your light is plug-in

Fix the bracket to the wall with the screws and anchors supplied, checking it with a level. Attach the body to the bracket, then run the cable to the nearest socket. Clip or tuck the cable so it is not a trip hazard and is not pulled taut where it leaves the fitting.

If your light is rechargeable

Fix the bracket to the wall, then charge the light fully with the supplied cable before its first use - a first charge from flat takes longer than later ones. Seat the light on its bracket and switch it on. Most models lift off the bracket for recharging without tools.

Important tips

  • Follow the wiring rules that apply where you live. If any part of this is unfamiliar, have a qualified electrician do it - it is a short job for them.
  • Check the outlet box is sound and can carry the weight of the fitting before you mount it.
  • Dust the fitting occasionally with a dry, soft cloth. Do not use solvents or abrasive cleaners on a painted or plated finish.
  • Let a bulb cool before you handle it, and never fit a bulb above the rated wattage.

If anything about the fitting or the wiring is unclear, email info@clerachic.com and a person will answer you.

Specifications
Dimensions, 1 head
∅6 cm × W 7 cm × H 36 cm (2.4″ × W 2.8″ × H 14.2″)
Dimensions, 2 heads, Left / Right
L 15 cm × W 7 cm × H 45 cm (L 5.9″ × W 2.8″ × H 17.7″)
Material
Alabaster, brass
Bulb base
G9
Bulb type
LED bulb
Voltage
AC 110–240 V
Control
Works with a standard wall switch (not included). The switch should be connected to an external wall light switch, allowing for a controlled electricity supply.
Wiring
Hardwired
Mounting
Wall
Finishes
Lacquered burnished brass & white, black & white, nickel & white
In the room

See it in the room

Bathroom with an arched brass mirror and marble vanity, a Clérachic alabaster wall light lit warm on each side of the mirror.
Living room corner with a walnut sideboard and an armchair, a two-head Clérachic wall light glowing amber beside a large abstract painting.
Sunlit living room with an armchair and a live-edge console table, a two-head Clérachic wall light lit warm beside a framed abstract print.
Detail of an alabaster cylinder shade on this Clérachic wall light, its pale, softly veined stone beneath a brass sphere and a slim arm.
Designed in Oslo The Clérachic edit Designed in Oslo
The object

Why you'll love it

  • White alabaster shade — each pattern and veining is one of a kind
  • Brass, black or nickel body to match your hardware
  • One head, or two heads in a left or right orientation
  • Warm ambient light for bedside, hallway or living room
Reviews

Reviews and photos

5.0 1 verified reviews · 1 with photos
Customer photo review of Alabaster Shade Wall Light, Wall Sconce, 36 to 45 cm Tall

“Totally Recommend. The quality and style are both outstanding. I will definitely recommend it to my friends!”

David W.Verified buyer

Read all 1 reviews

Customer Reviews

Overall rating: 5.0 / 5 from 1 reviews.

Customer photo review of Alabaster Shade Wall Light, Wall Sconce, 36 to 45 cm Tall

Totally Recommend. The quality and style are both outstanding. I will definitely recommend it to my friends!

Alabaster Shade Wall Light, Wall Sconce, 36 to 45 cm Tall

Store owner replied: So glad it found the right spot in your home. Thank you for the photo! Many thanks, Gerome from customer support

Complete the room

You might also like...

FAQ

Questions, answered

Which finish should I choose—Brass, Black, or Nickel?

All three metals pair with white alabaster shades. Brass & White offers warm vintage appeal; Black & White brings modern contrast; Nickel & White provides contemporary polish. Alabaster patterns vary per piece, so each sconce is unique.

What is the light source, and can I use LED or Edison bulbs?

This light uses G9 base bulbs—choose LED for efficiency or Edison for warm vintage glow. Both types work; LED sources are replaceable as they age.

How is this light installed?

It is hardwired to your wall and connects to a standard external wall switch (not included). Installation requires basic wiring; detailed guides and 3D files are provided with your order.

Is the alabaster shade the same on every lamp?

No—each alabaster shade has a unique natural pattern and veining, so yours will be one of a kind.

What sizes does this wall lamp come in?

One head measures ∅ 6 cm × W 7 cm × H 36 cm (∅ 2.4″ × W 2.8″ × H 14.2″). Two heads, left or right, measure L 15 cm × W 7 cm × H 45 cm (L 5.9″ × W 2.8″ × H 17.7″).

What if it isn't right for my room?

Return or exchange it within 30 days of delivery, unused and in its original packaging. No restocking fee. Return shipping is paid by you unless the item is defective, damaged or incorrect. Refunds are issued within 7 business days.

How long does delivery take?

Orders placed before 17:00 (GMT+1) are processed in 1–2 business days, then 6–10 in transit: 7–12 business days in total. Shipping is free on every order, and you get a tracking link by email.

What if it arrives damaged?

Email photos of the item and packaging to info@clerachic.com within 48 hours of delivery and we will send a replacement or refund.

Plain backdrop studio shot of this Clérachic wall light, two veined alabaster cylinder shades hanging at different heights from a brass wall plate.
Free advice before you buy

Not sure which size suits your room?

Tell us about the space, the chair it will stand beside or the ceiling height, and a person on the team will suggest a size and finish.

  • info@clerachic.com · we reply within 24 hours on business days
  • Monday to Friday, 09:00–17:00 (GMT+1)
  • Still unsure? Return or exchange within 30 days of delivery.