Clérachic round stair light switched off, a dark disc standing proud of a pale wall with one narrow slot down its centre.

Lampada per scale e vano scala, applique da parete rotonda, 9 cm, LED

Rettangolo - Bianco sabbia, 4 x 19 cm / Con sensore / Bianco caldo (2700-3500K)
€99,00
€99,00
Passa alle informazioni sul prodotto
Clérachic round stair light switched off, a dark disc standing proud of a pale wall with one narrow slot down its centre.
  • Clérachic round stair light switched off, a dark disc standing proud of a pale wall with one narrow slot down its centre.
  • Clérachic round stair light switched on, a warm amber line glowing in the slot and washing softly down the wall beneath the disc.
  • Clérachic round stair lights mounted in a line on the wall beside wooden stairs, four dark plates each casting a tapered warm beam across the tread below.
  • Clérachic rectangular stair lights recessed into a white wall that follows the stair line, each throwing a narrow beam down onto the dark wood below.
  • Clérachic round stair light seen at an angle on a grey wall, its slot lit cool white and the beam pooling on the floor below and to the right.
  • Clérachic stair lights set low along both sides of a dark corridor, laying narrow shafts of light across the wood floor towards a console table at the far end.
  • Clérachic round stair light set into the white wall beside a staircase, close up, its warm beam falling onto the timber tread below.
  • Clérachic rectangular stair lights fitted into the plinth of a cabinet run, each with a small round lens above the slot, throwing a triangular wash across the tiled floor.
  • Clérachic rectangular stair lights on a corner, a white plate switched off next to a black plate whose slot glows with a ribbed amber emitter, both carrying a round lens above the slot.
  • Clérachic rectangular stair lights in a row on a concrete wall above wide steps, three white plates each glowing amber and pooling light on the step below.
  • Clérachic stair light photographed side-on in near darkness, its round lens and lit slot picked out above a long beam raking across the floor.
  • Clérachic stair light in close-up at a low angle, its lit slot throwing a narrow raking shaft across a brightly lit cream floor.
  • Clérachic round stair light with a white face plate shown at an angle on its black housing box, the slot lit cool white and a bright shaft crossing the grey surface.
  • Clérachic stair lights in extreme close-up, one warm lit slot sharp in the foreground and a second blurred behind it, their beams raking across a dark floor.
  • Clérachic stair lights laid out together on a white surface, five white face plates on their recessed housing boxes, showing round, square and rectangular shapes with slots of differing length.
  • Technical dimension drawing of the Stair Light in all three shapes — Rectangle 19 × 4 cm (7.5 × 1.6″), Round ⌀9 cm (3.5″) and Square 9 × 9 cm (3.5 × 3.5″), drawn to one scale.
Lampada per scale e vano scala, applique da parete rotonda, 9 cm, LED

Lampada per scale e vano scala, applique da parete rotonda, 9 cm, LED

€99,00
€99,00

IVA inclusa, spedizione gratuita e resi facili.
Descrizione

Every staircase has that one step you take on faith in the dark. This stair light fixes that — a compact round wall sconce that switches on the instant it senses you, then fades out again the moment you're safely past.

You know the moment: fumbling for a switch with your arms full, or padding downstairs at 2am trusting your feet more than your eyes. Built-in PIR motion sensing paired with ambient light detection means this wall light only wakes when it's actually dark and someone's actually there — then it shuts itself off 35 seconds later, without you ever touching a switch.

The body is cast in solid aluminum alloy, built to take years of daily use in stride, and set flush into the wall for a clean recessed look rather than a bulky fixture jutting off your stairwell. Pick the light color that suits the space — Warm White for a cozy landing, White for crisp visibility, or Neutral Light for something in between.

Inside, an advanced LED chip and its own dedicated driver do the work: 3W of gentle, even illumination running on AC100-240V, so it's at home in practically any wiring setup. It's rated IP20 for indoor use, and this round profile measures 9 cm.
Specifiche del prodotto
IP rating IP20 (indoor use)
Light colour warm white, white or neutral white
Sensor PIR motion sensor with ambient light detection
Auto shut-off 35 seconds after motion stops
Power AC 100–240 V, 3 W
Rectangle 4 × 19 cm (1.6 × 7.5″)
Round ∅9 cm (3.5″)
Square 9 × 9 cm (3.5 × 3.5″)
Weight 0.4 kg (0.9 lb)
Material aluminium
Finish Black, White, Silver, Grey, Gold
Light source integrated LED
Dimming available on request, email info@clerachic.com
Voltage AC 90–260 V
Mounting wall-mounted
Certifications UL, CCC, CE, CQC, EMC, FCC, GS, LVD, PSE, RoHS, SAA, VDE
Technical dimension drawing of the Stair Light in all three shapes — Rectangle 19 × 4 cm (7.5 × 1.6″), Round ⌀9 cm (3.5″) and Square 9 × 9 cm (3.5 × 3.5″), drawn to one scale.
Guida all'installazione

Every wall light in this collection mounts to the wall with the hardware included in the box. The steps below cover all three power types we supply - hardwired, plug-in and rechargeable - so read the first section, work out which one you have, then follow the matching path.

Before you start

  • Power type: your light is hardwired, plug-in or rechargeable. The Product Specifications above say which. It changes the whole installation, so check before you open anything.
  • Mounting: all wall lights fix to a flat wall surface. Screws, anchors and the mounting bracket are supplied.
  • Dimming: lights with a standard replaceable bulb can usually be dimmed. Integrated LED models generally cannot. The specification above states which your model is.
  • Indoors or out: only fit a light outside if its IP rating says it is suitable. An indoor-rated fitting will fail quickly in the weather and is unsafe in the wet.
  • Wall type: plasterboard, brick and tile each need their own anchor. The supplied screws suit standard plasterboard; buy the right fixing for anything else.

Tools you may need

  • Screwdriver
  • Voltage tester
  • Wire nuts or terminal connectors (supplied with hardwired models)
  • Drill and a bit suited to your wall, if you are making a new fixing point
  • Spirit level and pencil

If your light is hardwired

1. Switch off the power

Turn the lighting circuit off at your consumer unit or breaker panel. Do not rely on the wall switch. Test the wires at the outlet box with a voltage tester and confirm they are dead before you touch them.

2. Remove the old fitting

If you are replacing an existing light, unscrew it and disconnect the wires by undoing the connectors. Support the fitting as you free it so it does not hang on its wiring.

3. Fit the mounting bracket

Hold the new bracket against the outlet box or your marked position and check it with a level. Fix it with the supplied screws, tightening evenly so the bracket sits flat against the wall.

4. Connect the wiring

  • Live to live: black, brown, or the terminal marked L
  • Neutral to neutral: white, blue, or the terminal marked N
  • Earth to earth: green, green-and-yellow, or bare, to the earth terminal or screw

Twist each pair together and secure it with a connector. Tuck the wiring back into the box so nothing is pinched when the fitting closes onto the bracket.

5. Mount the fitting

Line the body up with the bracket and secure it with the screws provided. It should sit flush to the wall with no gap and no movement.

6. Fit the bulb

If your light takes a replaceable bulb, fit the type and wattage given in the Product Specifications above. Do not exceed the wattage printed on the socket.

7. Restore power and test

Switch the circuit back on and test the light. If it does not come on, isolate the power again before you re-open anything.

If your light is plug-in

Fix the bracket to the wall with the screws and anchors supplied, checking it with a level. Attach the body to the bracket, then run the cable to the nearest socket. Clip or tuck the cable so it is not a trip hazard and is not pulled taut where it leaves the fitting.

If your light is rechargeable

Fix the bracket to the wall, then charge the light fully with the supplied cable before its first use - a first charge from flat takes longer than later ones. Seat the light on its bracket and switch it on. Most models lift off the bracket for recharging without tools.

Important tips

  • Follow the wiring rules that apply where you live. If any part of this is unfamiliar, have a qualified electrician do it - it is a short job for them.
  • Check the outlet box is sound and can carry the weight of the fitting before you mount it.
  • Dust the fitting occasionally with a dry, soft cloth. Do not use solvents or abrasive cleaners on a painted or plated finish.
  • Let a bulb cool before you handle it, and never fit a bulb above the rated wattage.

If anything about the fitting or the wiring is unclear, email info@clerachic.com and a person will answer you.
Perché ti piacerà
  • Aimed low — the beam leaves the slot and lands on the step or the floor below, well under eye level.
  • The box goes in, the plate stays out — the housing sits inside the wall cavity and only the slim face
  • No screw heads on the face — the plate reads as one clean piece with a single slot down its centre.
  • Three choices to make — plate shape, light tone, and sensor or no sensor
Quanto costa la spedizione?

Spedizione gratuita in Francia su ogni ordine, senza minimo d’ordine.

Ogni pezzo viene realizzato su ordinazione, quindi considera da 7 a 12 giorni lavorativi in totale. Ordina oggi e puoi aspettarti di riceverlo tra 22 September e 29 September.

E se non fosse giusto?

Hai 30 giorni per rispedirlo. Se non va bene, è facile restituirlo.
Ti serve aiuto?

Siamo a un’e-mail di distanza all’indirizzo info@clerachic.com: persone vere, prima e dopo il tuo acquisto.
Opzioni di pagamento
  • American Express
  • Apple Pay
  • Bancontact
  • Diners Club
  • Discover
  • Google Pay
  • Mastercard
  • Shop Pay
  • Visa

Rilassante per gli occhi

Una luce soffusa e calda che mantiene l’ambiente rilassante, mai intensa o asettica.

Fatto per durare

Materiali di qualità selezionati con cura e un design studiato per durare negli anni.

Spedizione sempre gratuita

Spedizione gratuita in Francia su ogni ordine, senza minimo d’ordine.

30 giorni per decidere

Provalo prima. Se non fa per te, restituiscilo entro 30 giorni, senza complicazioni.

Potrebbe piacerti anche...

Creato per ispirare. Costruito per durare.

Ogni pezzo è scelto a mano per la sua qualità artigianale, funzionalità e quei piccoli dettagli che la maggior parte dei brand trascura. Se non lo terrestimo per noi, non te lo venderemmo — e ogni ordine include la spedizione gratuita e 30 giorni per cambiare idea.

Domande prima di acquistare? Siamo persone vere, a un'e-mail di distanza: info@clerachic.com.